How to check if your water pipe is lead (5-minute test)
Updated November 18, 2026 · Sources linked in the text
Utility records are often incomplete. Looking at the pipe yourself takes about five minutes, costs nothing, and many utilities ask residents to send them a photo so they can update their records.
What you need
- A coin or a house key
- A fridge magnet (the stronger the better)
- A flashlight
- Your phone, to take a photo
Step by step
- Find where the water pipe enters your building. It is usually in the basement, a crawl space, a utility closet or the garage, often on the wall facing the street. It runs to your water meter and a shut-off valve. In warmer states the meter may be in a box outside near the curb.
- Look at the section of pipe before the meter, between the wall or floor and the meter. That is the service line. Do not test the pipes after the meter: those are your indoor plumbing.
- Gently scratch the pipe with the edge of the coin or key. Do not cut into the pipe or use a knife or file.
- Hold the magnet against the pipe.
- Compare with the table below and take a clear photo showing the scratched spot with the magnet on it.
What the results mean
- Lead: dull grey; the scratch shows shiny silver; a magnet does not stick; the pipe is soft and may have a rounded, bulb-shaped joint near the meter.
- Galvanized steel: dull grey; the scratch stays dull grey; a magnet sticks.
- Copper: the colour of a penny; the scratch is bright copper; a magnet does not stick.
- Plastic: white, black, blue or grey plastic; no metal shine.
Galvanized steel is not lead, but if a lead pipe ever sat upstream of it, lead can build up inside it. Records call this "galvanized requiring replacement."
Important limits
- You only see the few inches of pipe inside your building. The underground part, or the public side under the street, could be a different material.
- If the pipe is wrapped, painted, or you are not sure, stop and ask your water utility. Many will inspect for free.
- Wash your hands after touching an old pipe.
Tell your utility
Send your photo to your water utility. It helps them correct their inventory, and it may change whether you qualify for a free replacement. Many utilities have an online form for this. You can find your utility by checking your address.
The steps above follow the scratch-and-magnet method published by the EPA ("Protect Your Tap").